It should be indicated whether the day release is still activated and thus the door is not locked.
Armature contact - the sensor indicates the locking state of the strike
In DC operation, the electric strike does not unlock because the DC pre-load values are lower than AC.
Preload electronic assembly - improves pre-load characteristics in DC mode to min. 300N.
The door is released via an access control. If the door closes too quickly, the strike is still unlocked.
Monitoring contact - as soon as the door is opened, the power supply is interrupted and the electric strike is immediately locked again.
Wind, difference by e.g. Air conditioners or drafts push the door open during operation with mechanical day release.
Electric strike with strong latch spring - counteracts pressure. In order to minimize the snapping noise of the electric strike, we recommend the variant with noise damping.
A Low Energy swing door operator or door closer is mounted on the door. Which electric strike is suitable?
Electric strike with soft latch spring - reduces opening force on the door and reduces noise.
Suppressor diode (suitable for both direct and alternating current) - dissipates the high voltage that occurs when switching off coils and prevents further connected devices from being damaged.
The door should be open during the day via a timer. To do this, the strike must be permanently energized. Which variant is necessary?
Model 118 has only two voltage variants: 10-24V and 22-42V.
At 10-24V continuous current with 11-13V; at 22-42V with 22-26V.